![]() It takes entire 2 lines of code to enable this with no MQTT installed. I had to fight almost 20 bugs in Tasmota alone - please, no more add-on programs than this one! So, when needed, all my Tasmotas can send the data directly to my SmartHome computer - an RPi Zero. Amateurs mostly use MQTT, but that is quite bad as it needs several other programs to handle the data. This is useless since my LE9 hangs daily and then Kodi does not respond to any IR commands and I must pull out the power plug anyway.Ģ) good way: IR two-way blaster (a micro controller) as any other Tasmota Smart device can have two way communication with the controlling computer. There are 2 ways to power down Rpi:ġ) simple way: send IR command PowefOff to RPI and grab that same IR signal to kill its power 10 second later. We should all know we must never just kill the RPi by taking its power out. It does not matter if I wrote a Computer sciencex master thesis at Cambridge If I did write a complete SmartHome program, handling all the above things, I am likely computer literate. What I did is not a solution for everyone but is an excellent solution costing next to nothing. Hats and similar add-ons cost too much and still need good visibility. ![]() Try explaining it to your wife A random IR receiver connected to GPIO will react to any or too many signals. Plus, I can use my regular remote to powercycle RPi off/on when LE hangs.Ī psychical RPi switch may not be convenient. Now my RPis work just like any other remote control appliance for anyone using them. it is quite simple for them to shutdown / turn the RPi power off and back on with the corresponding remote command. ![]() Occasionally, LE will hang for no good reason which prompted me to connect them to independent external Smart Power on/off switches.Īs I already have IR blasters connected into my SmartHome system to control heating, cooling, shutters. So, I connected key devices to Smart Switches run by Tasmota fw and my programs. I want all of my systems to run 24/7 without any intervention.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |